Tuesday, 11 December 2012

Lab 6.2 Factors Affecting Reaction Rate

Lab 1 Seltzer Tablet

Purpose:

To observe how temperature affects the rate of a chemical reaction (Alka Seltzer tablet and water).

Hypothesis:

If the rate at which the seltzer tablet dissolves is related to the temperature of the water, than the hotter the water the faster a chemical reaction will occur.

Materials:

-Three 250 ml beakers
-Cold water
-Hot water
-Warm water
-3 seltzer tablets
-Stopwatch
-Thermometer
-Kettle

Variables:

Independent Variable: temperature of water
Dependent variable: rate at which an Alka Seltzer tablet dissolves
Controlled Variables: temperature of water (hot, warm, cold)

Procedure:

1.)  Fill each of the three beakers with 250 ml of either warm, hot or cold water (one in each)

2.)  Record the temperatures of each beaker

3.)  Place one Seltzer tablet into one of the beakers at a time

4.)  Wait for the reaction to completely finish in one, before starting another

5.)  Record the results of the remaining beakers

Results:

Cold water (10 degrees)with Alka Seltzer tablet:The Seltzer tablet dissolved in the 10 degree water in one minute, and 1:40.8 seconds
Room temperature (20 degrees) water with Alka Seltzer tablet: The Seltzer tablet dissolved in room temperature water in 51.4 seconds
Hot water (90 degrees) with Alka Seltzer tablet:The Seltzer tablet dissolved in the 90 degree water in 15.5 seconds

Discussion:

 In this experiment, we tested how temperature can affect he rate of a chemical reaction. We conducted a series of three tests, and each of the tests featured a beaker of water of a different temperature. In our Hypothesis we stated "If the rate at which the seltzer tablet dissolves is related to the temperature of the water, than the hotter the water the faster a chemical reaction will occur". Our hypothesis was correct, as shown in the results, that the lower the temperature of the water, the slower the Seltzer Tablet dissolves. This is shown in our results, that the boiling water (90 degrees) dissolved the tablet in a total of 15.5 seconds. This was the fastest time of all tests. The 'room temperature' water (20 degrees) dissolved the tablet in 51.4 seconds. The cold water however, dissolved the tablet the slowest with a time of 1 minute and 40. seconds. This proves that our Hypothesis was correct. In our experiment, we had three tests, and each had dependent, independent, and controlled variables. Our independent variable was the temperature of the water. Our dependent variable was the rate at which the reaction occurred. Our controlled variables were the amount and size of the Alka Seltzer tablets, amount of water, and the size of the beakers. If I were to do this experiment again, I would definitely try to make sure the temperatures were not so far apart as they were in out original tests. I would also use a full Alka Seltzer tablet as opposed to a half tablet.

Conclusion
 
  Our purpose to this experiment was to investigate how temperature can affect the rate of a reaction. We did this by doing three separate tests, each of which showed how these factors affect the rate of reaction. Our hypothesis was correct because the warmer the water, the faster the reaction. Our results proved our hypothesis correct when the hot water took the shortest amount of time to react with the table, and dissolve. The approximate half of an Alka Seltzer tablet took 1:40.8 seconds to dissolve completely in cold water. Where as the hot water (90 degrees) dissolved the tablet 15.5 seconds. With a time of 51.4 seconds the room temperature water took an average time to dissolve, it was the second fastest tablet to dissolve.

Lab 2: Zinc metals



Purpose:

To find out what level of concentration will dissolve the sodium bicarbonate the fastest.

Hypothesis:

If the rate at which the sodium bicarbonate dissolves is related to the amount of concentration in the solution, then the higher the concentration the faster the sodium bicarbonate will dissolve.

Variable:

Independent variable: the amount of concentration in the solution
Dependent variable: rate at which the sodium bicarbonate dissolves
Controlled variable: amount of vinegar, sodium bicarbonate, and the same surface area

Materials:

-Three different 100 ml concentrations of vinegar (0.5,0.25, 1)
-one scoop of sodium bicarbonate
-Three beakers (250 ml)
-Stopwatch

Procedure: 

1.) Label each beaker with each concentration of vinegar

2.) Pour 0.25, 0.5, 1.0 of  vinegar in each concentration in the three different beakers

3.) Place the sodium bicarbonate into each beaker

4.) Observe and record the results

Results:

0.25 and sodium bicarbonate: 3:07.3
0.5 and sodium bicarbonate: 1:59.5
1.0 and sodium bicarbonate: 1:10.3

Discussion:

In our hypothesis we stated that the higher the concentration the quicker the sodium bicarbonate would dissolve. Our hypothesis was proven correct, as the quickest rate at which the sodium bicarbonate dissolved was with a higher concentration of vinegar.It took 1:10 seconds for the sodium bicarbonate to dissolve completely in the highest concentration of vinegar (1.0).The second test resulted in dissolving in a total of 1:59.5 seconds in 0.5 concentration. It took 3:07.3 seconds for the bicarbonate to dissolve in the vinegar (0.25) during the third test. The results of the tests proved our hypothesis correct. Our independent variable was the concentration of the vinegar solution. Our dependent variable was the rate at which the Sodium Bicarbonate dissolved. If I were to do this test again, I would like to have exact measurements as to how much sodium bicarbonate we used in each test of our experiment.

Conclusion

 We proved our hypothesis correct, because during the experiment the highest concentration took the least amount of time to dissolve the sodium bicarbonate.The solution with the highest concentration took the least amount of time to dissolve the bicarbonate. The highest concentration dissolved at a time of 1:10.3. It was clear that the concentration was related to the rate of reaction when the lowest concentration took 3:07.3 to dissolve the bicarbonate.

No comments:

Post a Comment